Today I was going to make a few CC trips above 4000 feet. So for I haven't been over 3000 MSL so I haven't leaned my engine, which is a Lycoming 0-235. Today before take off I had my rpm at 1000 and I pulled the mixture and watched my EGT rise slightly. I was waiting for the engine to run rough or my RPM increase, neither happened. The engine just died. I tried  couple of times, but same results. Should I try the same process at say maybe 2000 RPM, closer to where the RPM will be at cruise?

Gil

Views: 340

Reply to This

Replies to This Discussion

does idle rise slightly  when shutting down ? If not your probably too lean with the mixture screw (50-100 rpm rise at shutdown is what I like to see)

1000rpm is right for most A/C engines an a 50rpm rise is about what you should see.  Check the engine operating manual for exact numbers. Your discription of the runup sounds like your good. 50rpm is hard to see on a bouncing tach an your engine has to be at operating temp to get a accurate reading on mixture rise. I would suggest you take it around the patch first an then do a mixture check after. If you adjust the mixture after a ground run it will be too rich. Get your numbers an go fly then do a check, I’m betting your good. 

Dave

RSS

New from Zenith:

Zenith Planes For Sale 
 

Classified listing for buying or selling your Zenith building or flying related stuff...


Custom Instrument Panels
for your Zenith
:

Custom instrument panels are now available directly from Zenith Aircraft Company exclusively for Zenith builders and owners. Pre-cut panel, Dynon and Garmin avionics, and more.


Zenith Homecoming Tee:


Zenair Floats


Flying On Your Own Wings:
A Complete Guide to Understanding Light Airplane Design, by Chris Heintz


Builder & Pilot Supplies:

Aircraft Insurance:

 
 

West Coast USA:

 
Pro Builder Assistance:

 

Transition training:

Lavion Aero

K&S Aviation Services

Aircraft Spruce & Specialty for all your building and pilot supplies!

How to videos from HomebuiltHELP.com

Developed specifically for Zenith builders (by a builder) these videos on DVD are a great help in building your own kit plane by providing practical hands-on construction information. Visit HomebuiltHelp.com for the latest DVD titles.

© 2024   Created by Zenith.Aero.   Powered by

Badges  |  Report an Issue  |  Terms of Service