I'm building a 601 quick build kit. I don't consider myself to be an expert but am wondering if there might be an alternative to cutting large holes into the side of each fuel tank in each wing for the fuel level sensors/senders. I remember seeing airplane fuel senders/gauges that required only a very small hole at the top of a fuel tank, senders that were a narrow solid state rod. But I can't remember where I saw them. Another builder has told me that it is possible to cut the hole in the top of the tank rather than the side and that the units that come with the kit are not very accurate (maybe because he installed different!!!!???). But I'm looking for a whole different fuel gauge/sender alternative and I'll bet that this has been discussed before. If anyone could help me with this I would appreciate it very much. Thanks. Sincerely, Charles Thie, Burlington, Iowa. I would also like to thank the members who responded to my prior two questions, thanks.
OK, no answers, no problem, I'll figure it out myself for better or worse. I'm 100% happy with the parts, but I wonder if I'm missing something on the builders page? I built a Quad City Challenger back in 2001 and when I posted a question on their website, there was almost immediate responce. So far I have not seen this on Zenith. Maybe I am missing a separate website???????? email@example.com
I know Steve Weston from this website has also had a lot of trouble with the senders and ended up installing them in the top of the tank. I think this is where they used to be installed on the earlier Zodiacs. For my money, it's the best place for them incase of a leak which seams to me to be quite likely. Sorry I can't offer any actual advice from experience as I have not installed mine yet.
Developed specifically for Zenith builders (by a builder) these videos on DVD are a great help in building your own kit plane by providing practical hands-on construction information. Visit HomebuiltHelp.com for the latest DVD titles.