Online Community of Zenith Builders and Flyers
If you are using the above carb you will need a flange to attach the SCAT hose to the air intake. A poster in the general discussion group came up with an inexpensive solution. Part # 10350-10 at Aircraft Spruce can be used to fashion a flange plate by welding or riveting a flat piece of aluminum sheet to it.
If anyone has a better solution I am open to it. This is the last piece I need to complete my airplane. Time is of the essence.
attached is a photo of one I made for my corvair, please note these are not the correct bolts, just temporary.
Good idea, great picture. Did you weld this?
The flange is held in place with square aluminum flange, no welding involved. The same flanges were used to make the air filter heat box.