Hi guys

I'm doing up my form blocks for the rudder, the top rudder tip block comes to a very thin 3mm at the end.

Since its so thin I'm going to make those blocks out of plywood. Hoping that's lends some support.

Any tips on shaping a rib around such a thin form

Thanks

Michael in Toronto

Views: 416

Reply to This

Replies to This Discussion

I'll fess up.  I made seven upper tail ribs, poorly, before I realized I should be using a brass hammer instead of the plastic hammer I had been using.  In fairness, I learned and got the lower tail rib done in one try.

Regardless, go slowly and don't try to get it all in one pass.

I did a video speciffically on forming the tip rib a few months ago because of the same question.  hope it helps, Dan.

https://youtu.be/U7HlBDLluhg

Hi Dan,  I watched you video.  Neat.  I am a kit builder but was interested anyway.  One question is what do you do with the two holes for tip ribs?  Do you just leave them or do you seal someway?

Hi Joe:  Leave the holes, but one of them will be opened up and a grommet installed for wiring for the strobe.

Joe: I have provided you with incorrect information and you have found a flaw with my video of forming the rudder rib. It does not have any tooling holes in it. I was thinking about it this evening and got out the plans which shows no holes. I then went to the airplane factory to look at my rudder and was happy to find that it has no holes. The holes in the form block were put there to hold the form blocks together and aligned when I built the blocks themselves. when I formed my rudder rib the aluminum was held in the blocks with clamps and the vise so it has no holes. I will go back and edit the video to point this out. Great reminder to always check the plans. Thank you, Dan.

Glad I was able to help in some small way.  Keep up the good work.  I have considered some videos but just never seem to make the time.

I will add my video to the list as well https://www.youtube.com/watch?v=GOOy9W8IR_Y&t=1168s

It does not cover the tip rib like Dan's does, but there may be some things you might find useful.

RSS

New from Zenith:

Zenith Planes For Sale 
 

Classified listing for buying or selling your Zenith building or flying related stuff...


Custom Instrument Panels
for your Zenith
:

Custom instrument panels are now available directly from Zenith Aircraft Company exclusively for Zenith builders and owners. Pre-cut panel, Dynon and Garmin avionics, and more.


Zenith Homecoming Tee:


Zenair Floats


Flying On Your Own Wings:
A Complete Guide to Understanding Light Airplane Design, by Chris Heintz


Builder & Pilot Supplies:

Aircraft Insurance:

 
 

West Coast USA:

 
Pro Builder Assistance:

 

Transition training:

Lavion Aero

K&S Aviation Services

Aircraft Spruce & Specialty for all your building and pilot supplies!

How to videos from HomebuiltHELP.com

Developed specifically for Zenith builders (by a builder) these videos on DVD are a great help in building your own kit plane by providing practical hands-on construction information. Visit HomebuiltHelp.com for the latest DVD titles.

© 2024   Created by Zenith.Aero.   Powered by

Badges  |  Report an Issue  |  Terms of Service