Dynon D-180 HSI display

OK, I'll admit my ignorance and ask that you do not snicker too loudly as you (hopefully) help me figure this out;

I have a D180 installed in my 601xl

I just recently wired my panel mounted Garmin 296 into the D180 to provide HSI information.

When I Fly with HSI displayed it looks like I'm getting almost all of the information I am supposed to get;

TRK, SPD, and DTW are displayed on the top right, "GPS" is displayed on the top left. I also get the "hollow" yellow Course Indicator.

The problem is I'm not getting the soild purple ("Magenta?) CDI line as shown in the Dynon manual.

Is there something that I need to do to add the CDI to the display?

Thanks

Brad Cohen

N969BC 39.7 hours (I know! another 18 minutes. but it was really bumpy last flight and I had already looged 1.7.  There's always tomorrow)

Views: 493

▶ Reply to This

Replies to This Discussion

Permalink Reply by David Krakowsky on October 25, 2016 at 12:38am
Are you entering a route or airport into the gps?
Dave
Permalink Reply by brad cohen on October 25, 2016 at 12:47am

The two points I've been using are from my home base of ZPH to the center of my test area and back. both points are entered in the GPS

Brad

Permalink Reply by David Gallagher on October 25, 2016 at 10:42am

Brad,

I get a magenta line on my D180 CDI from my 296.  I also get the magenta V and triangle on my compass bar.  All I can offer up is the information I used to hook them together and see if you did the same:

Purple wire from Garmin 296 goes to D-180 DB37 connector, pin 19.  Set 296 COM1 to "Aviation IN/NMEA & VHF OUT." Set baud rate to 9600.  In Advanced NMEA settings screen, select "normal."  Manual pages 116-119.

This is all I recall doing and the magic magenta line just appeared.

Good luck,

Dave

Permalink Reply by David Krakowsky on October 25, 2016 at 10:29pm
Here's what mine looked like today.
Dave
Attachments:
Permalink Reply by Samuel McNair on November 22, 2016 at 11:26am
Had same issue a while back. Also found that you have to have a route or destination airport active in a GPS flight plan or no purple line in HSI.

Getting ready to install a new GNC 650 WAAS approach gps and tie it into the Dynon. Wish me luck

RSS

New from Zenith:

Zenith Planes For Sale 
  

Classified listing for buying or selling your Zenith building or flying related stuff...

Custom Instrument Panels
for your Zenith:

Custom instrument panels are now available directly from Zenith Aircraft Company exclusively for Zenith builders and owners. Pre-cut panel, Dynon and Garmin avionics, and more.

Zenith Homecoming Tee:

Zenair Floats

Flying On Your Own Wings:
 A Complete Guide to Understanding Light Airplane Design, by Chris Heintz

Builder & Pilot Supplies:

Aircraft Insurance:

 
 

West Coast USA:

 
Pro Builder Assistance:

 

Transition training:

Lavion Aero

K&S Aviation Services

Aircraft Spruce & Specialty for all your building and pilot supplies!

How to videos from HomebuiltHELP.com

Developed specifically for Zenith builders (by a builder) these videos on DVD are a great help in building your own kit plane by providing practical hands-on construction information. Visit HomebuiltHelp.com for the latest DVD titles.

© 2024   Created by Zenith.Aero.   Powered by

Badges  |  Report an Issue  |  Terms of Service