The standard 701 rudder peddles are difficult to use without depressing the brakes as well. For me, I need to angle my feet so just my toes press on the peddle, which is uncomfortable, then if I need to hit the brakes quickly (such as short landing) it’s awkward. I had round stock welded to the front of the peddles, that helps, but not much.

I'm thinking about raising the whole peddle assembly a couple of inches, so I can get the horizontal peddle bar into the ball of my foot. Using either blocks or brackets. 
Has anyone seen anything like this done? Any suggestions or alternate ideas?

thanks,

Dennis M

Views: 402

Reply to This

Replies to This Discussion

Dennis,

You could tilt the top of the pedals forward toward the firewall a bit by shortening the threaded rods that run from the pedals to the nose strut through the firewall. First  determine how much you can safely slacken (lengthen) the rudder cables by lengthening the adjustable barrel rod ends back at the rudder horn while maintaining the minimum thread engagement in the barrels. Otherwise you’d be looking at fabricating and installing longer rudder cables. If you do make any adjustments also double check you still have the minimum rudder deflections. Just a thought.

Thanks, I did tilt them forward, that helps, but also puts the brakes at more of an angle and slightly harder to press. I got another EAA member to look at my idea today and I’m feeling pretty good about lifting the peddles using some aluminum square stock. I’ll start with one inch and see if that helps.

thanks,

Dennis M

Dennis

I had the same problem, so I made some 1/2" thick aluminum plates to attach to the rudder and brake pedals.  It solved all my problems. Now I can use the toe brake and rudder as you would in a Cessna.  I will try to find and attach a photo of my solution.

Jim

Dennis

Here are the photos.

Jim

Attachments:

Very nice. Thanks for the shot from the back, helpful.

Dennis M

I thought mine were too short too, but now I am not sure.  I did some moving things around after running out to the airport and measuring a couple of cessnas.  The pedal heigth was anywhere from 5.5 to 7" but the toe brake was offset back towards the firewall by 1 to 1.5".   So I moved the hinge pivot from the top of the pedal to the back side and added a non-slip aluminum piece.

I think it is going to work fine now.  I had posted my thought that my pedals were too short also this morning on the facebook Zenith Builders page.

RSS

New from Zenith:

Zenith Planes For Sale 
 

Classified listing for buying or selling your Zenith building or flying related stuff...


Custom Instrument Panels
for your Zenith
:

Custom instrument panels are now available directly from Zenith Aircraft Company exclusively for Zenith builders and owners. Pre-cut panel, Dynon and Garmin avionics, and more.


Zenith Homecoming Tee:


Zenair Floats


Flying On Your Own Wings:
A Complete Guide to Understanding Light Airplane Design, by Chris Heintz


Builder & Pilot Supplies:

Aircraft Insurance:

 
 

West Coast USA:

 
Pro Builder Assistance:

 

Transition training:

Lavion Aero

K&S Aviation Services

Aircraft Spruce & Specialty for all your building and pilot supplies!

How to videos from HomebuiltHELP.com

Developed specifically for Zenith builders (by a builder) these videos on DVD are a great help in building your own kit plane by providing practical hands-on construction information. Visit HomebuiltHelp.com for the latest DVD titles.

© 2024   Created by Zenith.Aero.   Powered by

Badges  |  Report an Issue  |  Terms of Service