I have been looking at building a pair of penetrating skis. Couple of reasons but getting the plane back into the hangar would be way easier with wheels. Wondering what depth should the tires be below the bottom of the skis. Has any one found what works the best? Thanks in advance. Stan

Views: 575

Reply to This

Replies to This Discussion

Check out Bob McDonald's Wheel Skis on this site.

not giving a real answer here , but i figure that in a normal landing on pavement the skis should just , or just not, touch. Tire pressure can be varied to achieve that. Too much ski clearance results in more drag in the snow from the wheels.Skinnier tires at higher pressure result in less drag in the snow. I doubt if anyone has figured the perfect configuration

harmen

Stan, the first wheel penetration ski's i had were Schnieder Wheel ski's and they penetrated 2", they had a small wheel on the ski tail also , a rollerblade wheel , the ski bottoms were covered with black UHMW, it does'nt sun degrade as fast as white , and there were plates that could be slipped in under the wheels , by letting out air and then pumping up to hold plates down,.I sell the plans for straight ski's , they were designed years ago by Chris and he turned the project over to me , the plans are $35 and cost about $550 for all 3 , work very well on 701/750 aircraft...BOB 

Good morning Bob,

I own a CH 750 STOL and would like to build or buy penetrating wheel skis.

Do you have pictures or videos of the skis on a 750 STOL?

Did you modify Chris' design to make them into a penetrating ski? Would they be longer and wider than straight skis to compensate for the tire drag?

Al my ski flying has been in Super Cub, Canuck, 170B, all tail draggers and straight skis. Now based on asphalt runway with no way to get to and from hangar on straights. 

I was thinking to go Datum skis until a friend of mine who flew them on a Kitfox IV, told me the actuators were not strong enough to go from skis to wheels and ended up having toi replace one of the actuators. He now flies a Highlander and made his own penetrating skis. He is on 8.50-8's and my tires are 21" Tundra mains and 16" nose. 

I'd like to see pictures of them mounted (or not) and if it is do-able to make them into penetrating, I'd like to buy your plans for them. My Gross Weight is 1440 Lbs and my engine is the 912-is and Kaspar prop.

Thank you for any help or advise.

Thank you, 

JD Houde, Ontario, Canada

RSS

New from Zenith:

Zenith Planes For Sale 
 

Classified listing for buying or selling your Zenith building or flying related stuff...


Custom Instrument Panels
for your Zenith
:

Custom instrument panels are now available directly from Zenith Aircraft Company exclusively for Zenith builders and owners. Pre-cut panel, Dynon and Garmin avionics, and more.


Zenith Homecoming Tee:


Zenair Floats


Flying On Your Own Wings:
A Complete Guide to Understanding Light Airplane Design, by Chris Heintz


Builder & Pilot Supplies:

Aircraft Insurance:

 
 

West Coast USA:

 
Pro Builder Assistance:

 

Transition training:

Lavion Aero

K&S Aviation Services

Aircraft Spruce & Specialty for all your building and pilot supplies!

How to videos from HomebuiltHELP.com

Developed specifically for Zenith builders (by a builder) these videos on DVD are a great help in building your own kit plane by providing practical hands-on construction information. Visit HomebuiltHelp.com for the latest DVD titles.

© 2024   Created by Zenith.Aero.   Powered by

Badges  |  Report an Issue  |  Terms of Service