I'm David Banahan.  I live in Campbellsville KY (KAAS).  I have met two young men who are ferrying a 750 STOL from Charlotte, NC to somewhere in Idaho.  The problem they encountered is while in flight the right door began to oscillate and disintegrated.  They were able to hold on to the frame and most of the acrylic.  They diverted to the nearest airport (KAAS) and landed without incident.

They are flying at about 40 lbs below gross weight.  If they remove the other door what will be the flying characteristics of the airplane be like.  I need your help to gain enough information for the PIC to decide if it is safe to continue with A. one door B.  no doors C.  or should they abandon the flight altogether?  

Your thoughts appreciated,

David Banahan

270-784-9299

Views: 714

Reply to This

Replies to This Discussion

Hello David...

I suggest you contact the Zenith factory for this inquiry.   Roger or Sebastian are best qualified in terms of both flight experience, structural knowledge and flight characteristics in this case.   

Readers, like me, would be interested in more details like air speed and relevant wind conditions that precipitated this event.  

The factory may want this information as well.  Certainly gives one pause.  Questions may arise as to build quality as well.   

If you get more details please advise, including Zenith’s response.  

RMM

Thanks, good idea, I'll get the PIC to get in touch with them tomorrow.  Even if Zenith sells them a door is there a repair station to do the installation at Mexico?

Another link with better hits for this problem...

http://www.zenith.aero/main/search/search?q=bubble+door

RMM

Roger has a video  flying the 750 w.o. doorS. Worked well.

Hello David..

Zenith is known for its outstanding support. If a door replacement is called for, then the requisite builder plans and instructions should be requested along with the replacement parts. Shipping to your location should not be too time consuming. This site is closely followed by experienced builders who can guide the crew or an A&P as needed.

You may find some builders or owners of the CH750 STOL aircraft nearby. People here are amazingly friendly and supportive.

A general search of this forum will likely provide additional repair guidance from actual builders if the decision to replace the door is made.
Try this link... http://www.zenith.aero/main/search/search?q=replace+door

If you see a related post, send a PM to the member.

Let us know how this progresses.

RMM

And See This Discussion...

Of course, may not apply if doors off flight is approved.

RMM

http://www.zenith.aero/group/stolch750/forum/topics/bubble-door-bes...

You can call the main number at Zenith pretty early. I believe Roger gets in a 6:30 or so (CDT), and starts answering phones around then as well.

Per reply from... Del Clowes

One video shown with Air Deflectors for comfort from the air flow.

RMM

https://www.youtube.com/watch?v=cfQM3jz1kh4

https://www.youtube.com/watch?v=7WfFDQf1ZrM

the PIC flew it to an uneventful landing...he should be able from that to evaluate whether it's airworthy to his satisfaction. He's the man with that recent specific experience; that's an unusual configuration and I doubt anybody here will be able to give him any info better than what he already has firsthand.

I heartily agree that I would seek the guidance of someone like Roger at Zenith.  Out of curiosity, however, did the doors have any sort of latch system on the forward/leading edge of the door?  Was this one of the original fiberglass doors?  The bubble definitely produces lift, pulling on the door.  If the leading edge bows out enough to catch the slipstream, then the positive pressure yanks the door open and the door is usually destroyed.  A very simple latch to ensure the door doesn't catch air is all that's required to totally prevent this problem.  This simple latch, tensioned by slipping a piece of fuel hose over the pivot bolt, has worked great for me for 6 years/550 hrs:

Again, I defer to Roger, but I would be concerned flying with one door off/open that if the plane is yawed much at all, the cabin might suddenly pressurize and blow out the opposite/closed door.  It definitely would be better if the remaining door is secured on the leading edge but probably the most effective thing short of installing a new door and 2 latches would be to fly doors-off (flying both doors-off is a Zenith-approved configuration) until the broken door can be replaced.

John

N750A

Believe you said they got most of the plastic. If so maybe they can gorilla tape all that in addition to the leading edge of the door and make it on home.

Thanks everyone for their advice.  Roger says the plane will fly just fine at full gross without doors.  In 701's losing a door is a rare phenomena.  Anyway the ferry pilots got picked up and flown home.  The new owner is coming later this week to replace the door and fly it to Idaho.  Problem solved.

Thanks again

David

RSS

New from Zenith:

Zenith Planes For Sale 
 

Classified listing for buying or selling your Zenith building or flying related stuff...


Custom Instrument Panels
for your Zenith
:

Custom instrument panels are now available directly from Zenith Aircraft Company exclusively for Zenith builders and owners. Pre-cut panel, Dynon and Garmin avionics, and more.


Zenith Homecoming Tee:


Zenair Floats


Flying On Your Own Wings:
A Complete Guide to Understanding Light Airplane Design, by Chris Heintz


Builder & Pilot Supplies:

Aircraft Insurance:

 
 

West Coast USA:

 
Pro Builder Assistance:

 

Transition training:

Lavion Aero

K&S Aviation Services

Aircraft Spruce & Specialty for all your building and pilot supplies!

How to videos from HomebuiltHELP.com

Developed specifically for Zenith builders (by a builder) these videos on DVD are a great help in building your own kit plane by providing practical hands-on construction information. Visit HomebuiltHelp.com for the latest DVD titles.

© 2024   Created by Zenith.Aero.   Powered by

Badges  |  Report an Issue  |  Terms of Service