Hi Mark,

I am completing a 750 with 130 viking, large spinner like yours. I would like to talk to you about cooling of the engine. I have not installed the NACA inlet yet, nor have I cut the hole behind the spinner. I want to see if the naca inlet is really necessary and if the cowl is strong enough after cutting the slot all the way around the back plate.

my email: cap149149@gmail.com , cell 803-415-1974

Thanks,

Bob Ownbey

Hello Mark,

I am building a CH750 STOL from kit, and going Viking 130. Look forward to see how your install goes.

Mark, I just noticed that you picked up a Viking 130.  I am located in Lorain County and I would like to stop by to see the 130.and talk about the installation.  I am currently flying a 1946 J3 Cub and I have a set of plans for a Zenith 750.  I purchased the Cub last summer to build my tail wheel time and my hours.  I have been following the Viking Engines since Jan started building them.  Pardon my inviting myself but I am really excited about seeing this engine.  Thank.  I will send info on PM.  Joe B