Online Community of Zenith Builders and Flyers
I have a dual throttle setup on my 701 with a Rotax 912ULS This is the kit that zenith provides with two cables. There seems to be a lot of pressure pulling the two throttle arms on the carbs back to full. If I take my hand off the throttle it will advance the RPM greatly. I have to tighten the throttle lock down very hard to stop this action. Rotax says not to change the carb springs. I took the springs off to see if it was a cable issue , but no problem with the cables. I did reattach the…Continue
I need help on how to make the mixer lever move smooth. I made several triangle horns to make it work. the whole thing gets stuck open or closed at times
I have spent too many hours on this task which I thought would be easy. HELP
Pictures would be nice.
Is there some type of boot for the two threaded rods that control the front nose wheel? Trying to keep engine compartment smells from entering the cabin area.
Added by Jerry Griego on October 20, 2010 at 12:14am — No Comments