Plumbed through the ribs, added a junction box on top of servo and will run Tefzel single run from servo to switch, eliminating all connections.…

Designed elevator end caps for the Cruzer. Designed a little oversized (20mm) flanges to trim back to personal desired fit.

Template/Dimensions (approximate, your fit may vary). …

Nice day, so I pulled the Cruzer out of the shop for a first run. 

150 hp 0-320 lyc.  All ran smoothly, no precious fluids leaking.

Had Michael Garber Studios design my final color scheme for the L750 Cricket.

I haven't posted in quite awhile. I am working at a very slow pace due to time constraints and perfectionism. I have lots of updated photos to show.

Recently, the trusty 912S in my 701 has been, well, not that trusty. The symptoms started subtly about a year ago, with slight difficulty starting. Used to be, you couldn't count the blades before the thing sprang to life. Now I was counting 6 or 10 seconds, and having to mess with various combinations of throttle and choke - probably because the lack of immediate start was causing flooding.

Anyway, I had an annual inspection coming up, and even though I have my repairman…

After flying my  HDS for 10 and half years, decide to upgrade the instrument panel in order to relieve some COVID fatigue.  Purchased an inexpensive CNC router to make the cutouts and learned to use the software to make the drawings and generate the GCODE.

Was able to clean up some wiring and remove unnecessary instruments.  Still getting used…

I am trying to find information on how to properly set the flaperon position. I have recently completed a set of high strength turnbuckles to assist in the setting process. I have looked through all the documentation I have and can't find any pictures or angle information, maybe I am too OCD but I want to get this correct. I started by laying a straight edge on the top rear of the wing and adjusting to that but when I have completed the settings I don't have much flaperon movement with the…

I ordered the landing light kit for the 750 and started looking for instructions on how to install it. I found a few examples of what the final product looked like but nothing like what I needed as a VERY armature builder. Well, I decided to tackle the project and I figured I'd pass along what I did in case it might help someone else.

The first thing I found is that either I build the slat wrong or the SD slat is different than the 750 STOL. I say this because the pictures and…

Video documenting my process for folding the nose skin for my Zenith 650.

I would not call this video exciting, but I'm starting a new YouTube series to document the building of my Zenith CH750 Cruzer. This Introduction shows the new format, which uses 3 cameras to film the construction and shows off the workshop. Once construction starts, in a few weeks, the work will be live streamed. Each day of work will then be compressed into time lapse at 60 times normal speed. I am not trying to become YouTube famous, just document the entire process of building a…

It's always an exciting day when you just get to rivet! Assembled the elevator for the final time. These are the days that make me want to invest in a pneumatic riveter, I think I will for the fuselage. 

The stabilizer was finished my junior year in college, will just tack rivet elevator for now.

Rudder I'm holding was finished by my granddad at the Zenith factory in 1993.…

Sequence of pictures each hyper-linked to my eaa builder log which show details of Corvair flight engine short block assembly.

Corvair Flight Engine Short Block Assembly (corvair750.com)

A look in the review mirror: 2020

Subscribe to the weekly build series HERE

I have decided on my color scheme and have already ordered my paint. Going with a commemorative L4 Grasshopper. I am looking for a supplier of Leather seat coverings. Any suggestions?

Zenith Aircraft Building Workshop Is Coming To Hondo, Texas on February

• 2/17/21 UPDATE: Rescheduled due to Winter Weather in Texas! The hands-on workshop (which is at…