Steffen Glatz's Page

Steffen Glatz posted a discussion

Jabiru Regulator ?

Hello,to all other problems it seems that the generator produced not voltage to the batterie.First thing to check is the regulator. (picture).In and out is clear to so far, but what are the green and yellow wires good for ?What does the green one, a 12V Lamp or a LED ?What does the yellow one, the actual currant in V from the generator ?Is there any V on the yellow one if the engine is off ?please let me know.Thank you all.Steffen…See More

Apr 3

1 Comment 0 Likes

Steffen Glatz posted a discussion

Checking the Bing 94 CV for 3300

Hiho,as I wrote in the "3300 low power" thread we are continuing to troubleshoot the low RPM.It has already shown that obviously a rather small main jet (245) was installed. I will get a selection of nozzles, especially the 255 default nozzle, as well as 260, 265 and 270 to try.Someone told me the nozzle needle also comes in two versions, one with many mounting grooves on top and one (eco?) with only one mounting groove. Which is the right one for the 3300 ?The fuel supply is best from the…See More

Jan 5

8 Comments 0 Likes

Steffen Glatz posted a discussion

3300 low power ?

HiHo,I suspect that my Jabiru 3300 motor is underpowered because it does not get up to the required RPM when stationary on the ground. I reach a maximum of 2100 rpm.It has no measurable effect when using different propellers from the same manufacturer and identical length (Helix). I have tried propellers with 10, 11 and 12 degrees pitch and always the same effect, never more than 2200 rpm when standing on the ground.Today I removed the air filter and the supply air now comes directly into the…See More

Dec 31, 2020

35 Comments 0 Likes

Steffen Glatz posted photos

Oct 5, 2020

Steffen Glatz posted a discussion

3300 thermocouple for Dynon ?

Hello,I own the old ring-type J thermocouple for my Dynon FlightDEK that is located und the spark plug.It is a known issue that in this location the CHT is always shown far to high.There is no compensation feasibility in the software setup for that issue.Jabiru has therefore issued a retrofit instruction for the thermocouple.…See More

Oct 4, 2020

2 Comments 0 Likes

A photo by Steffen Glatz was featured