To all 601XL and 650 builders and aircraft owners. If you have a specific question regarding the upgrade, post it here and I will consult with Chris Heintz so that we can give you the best possible answer. Please be specific about your questions.
When posting a question or replying to an existing comment, PLEASE add it to end of the last page.
Zenith Aircraft is upgrading its 601 XL, so a lot of questions are answered on the step-by-step Blog Posts on this main page.
All the CZAW built 601 XL's have the hinged ailerons so this was not addressed in the UK LAA mandated upgrade. However, even though there is possibly less chance of vibrations and or flutter with hingeless ailerons, we cannot say for sure so we want all aircraft to upgrade. The German flutter report clearly states that there are no flutter issues with the aircraft when properly rigged. However, in the name of safety, it is important that everyone upgrade.
So if this is the case and I now have to remove my hingless ailerons and install hinged ones is there a Zenith approved Plan and Photoguide now on how this is to be done. I may not use the correct strength hinge or L anges or , rivets?
Of course it is important for everyone to upgrade. That is understood. What is now becoming unclear is exactly what the upgrade is. It is my understanding that the structural upgrade is what is required in the 3 drawings provided by Zenith. I have 4 questions:
1. Does the upgrade require(by the FAA) replacement of hingeless ailerons with hinged ones?
2. If so, do the hinged ailerons need to be mass balanced
3. Does the upgrade reqiure any modification to the 601xl elevator trim system.
I want to upgrade my 601xl, NOT turn it into a 650.
4. Additionally, Zenith and the FAA have issued an instruction. Is this, or is it not, independant from the British LAA insruction
If you have the hingeless ailerons, you do not need to convert them to the hinged ailerons. Just add the counterweights and rest of the upgrade. The upgrade has nothing to do with making a 601 XL into a 650. This upgrade is for the 601 XL and the 650. For the installation of the aileron counterbalance weights, we are using the UK LAA drawing and instructions but extending that the the hingeless ailerons. Zenith is not changing that. However, we are not following the rest of the UK LAA modifications. For the elevator trim tab, we are not changing that. However we are adding "L" angle stiffeners to the trim servo area as the elevator skin flexes easily.
OK. Given that flex ailerons are the standard setup and that we have to install mass balance weights. is it possible to modify the flex ailerons to accept a piano hinge? For example if a standard "L" is installed on the under aft side of the flexing skin to accept the piano hinge this would we don't have to make another aileron!
Ian -- Clyde Barcus posted a message with photos on the ZBAG forum dated 11/10/09 describing this modification to his 601XL. In an earlier post he mentioned discussing the mod with CH prior to doing the work. He added an L-angle between the bottom of the hinge and the front of the aileron.
The upgrade may include stiffening of the elevator trim motor. Other than that, I do not foresee other changes in the tail area.
We hope to have the upgrade drawings 100% finished next week. AMD and Zenith are presently upgrading an aircraft right now where we are verifying everything. You can view the Zenith upgrade in the blog section of this site. Once this is all done, we hope to update the 650 drawings within the next 2 to 3 months or sooner.
Custom instrument panels are now available directly from Zenith Aircraft Company exclusively for Zenith builders and owners. Pre-cut panel, power distribution panel, Approach Fast Stack harnesses, Dynon and Garmin avionics, and more.
Developed specifically for Zenith builders (by a builder) these videos on DVD are a great help in building your own kit plane by providing practical hands-on construction information. Visit HomebuiltHelp.com for the latest DVD titles.