Online Community of Zenith Builders and Flyers
I have a brand new Ed Serba wood prop and face plates and extension for an XL601b 0-235 C1B I was going to use on my XL I was building, but instead I bought a flying XL. I would discount it a couple a hundred dollars from what I paid. Again brand new, just test fitted on my engine
What is the length and pitch? How did you determine the choice of this prop for your C1B. My engine is a C2C. I was just looking for first hand knowledge and experience to help guide me with this decision. What are you using on your flying XL and how does it perform? I know there are not a lot of flying 601 XL's with lycomings so it might prove difficult getting an answer.
Please message me with the price of your prop.
The prop is 68/57, the one that is used on a factory 601 XL. I have a three blade warp drive that came on my 601. I cruse at 2400 RPM indicating between 115-120 MPH at 7 GPH. I have the L2C engine. Will have to look up what I paid. You need to check on your hub as from what I understand there are a couple of differing hole centers for the 0-235
That looks like the prop flange on my engine, but I better make sure. How much for the Serba prop?
Mike I have $1,213.oo invested plus shipping. I won't sell just the prop as I would have no use for the bolts extension, and crush plate . I would take a thousand dollars plus actual shipping for the prop, prop extension, custom bolts and washers, and crush plate. These are all parts designed for the Lycoming 0-235 installed on the Zenith XL 601B using the Zenith factory cowl and engine mount. With out the extension the prop has a very good chance of rubbing on the back of the prop.
According to the Lycoming manual, my bolt pattern is AS-127-1.
A visual inspection is not enough to determine the difference between AS-127-1 and AS-127-2. I have no reason to doubt the manual and my engine case has never been disassembled.
The O-235 came with either an SAE-1 HUB or an SAE-2 hub. You can tell which one by measuring the bolt hole spacing. See attached.
I think I will stick with the warp drive propeller, but thanks for the offer.
Contact Daryl at warp drive. He will help you make the correct choice.
I have a 68" 3 blade warp drive prop with the HP hub on my 601 with the O-235-C1 engine. I have the tapered tips but did not spend the extra money on the nickel leading edge (but wish I had).
I have a Brand New Warp Drive 3-Blade 68" Prop with the HP hub that we were going to use on a Lycoming o-235 project but have since ended up going a viking route with DUC prop. please send me a message if you are interested.
Do you still have your prop for sale?