Online Community of Zenith Builders and Flyers
Hi everyone Im starting the cage install on the 750, there is a
problem lining up the lower fuselage section and cage I have about
45mm offset to the rivet holes. the upper portion has been trimmed
and clecoed to the fuselage with no problems. Why is there such a discrepancy for and aft with the lower portion? I measured the wing
attach points and these check out ok. if I try and align the frame tubes
and rivet holes there is to much of an angular discrepancy. Anybod else heve this problem?
If I recall I had to cut about 10-15mm off the bottom to line up with rivet holes.
thanks guys for the help. One other question, the small hole in the cage goes into the lowest hole on the fuselage like on the upper mount, Correct?