Hi everyone,

We are rapidly approaching something I have been dreading since the build began, mounting the cowl.

Our plane is a 750 Cruzer..... Engine Aeromomentum AM15.....Cowl is carbon fiber.

We are seeking any advice on how to go about mounting the cowl. I tend to like the extruded piano hinge method, but at this point we are open to any attachment method that works and holds up over time.

We have not trimmed any of the aluminum that extends forward past the firewall, nor have we trimmed any of the cowl, except around the nose gear. I can attach pics of the cowl/firewall/engine, if that helps.

Seeking the following:

- Pics of your cowling installations and attachment methods.

- How much to cut out of the bottom around the nosegear/exhaust for airflow???

- Where to trim the aluminium, flush with the firewall or ???

- What size of extruded hinge to use??? Or other fasteners???

- Should we mount some plywood to prop spacer to hold the front of the cowl temporarily???

Thanks

Views: 642

Reply to This

Replies to This Discussion

I'll attach a couple photos of my cowl. I pretty much followed the Viking method. The top hinge is a 2" and a 1.5" split and put back together with each leaf different width. I did not trim any aluminum. They come off easily, back on--not so much. Seems solid enough.

Attachments:

Jim, did you use the smaller diameter pins?

Yes, I used smaller music wire for pins and prebent them a bit to match the curve. It would very difficult to reassemble with full size pins. In addition, I ground a bit off each knuckle, so they line up easier,

Jim, everything is looking really nice by the way :) We have that whole kit available here where Jan even does all that and it has the undersized pins and you get the right amount needed for the job! It can be really difficult to pull out if you don't use the undersized pins.  -Alissa

I used the original pins, but I chucked them into a drill and spun them against some Scotchbrite.  Then used ordinary white candle wax as a lubricant.

Works outstanding.  Pins slide in very easy, and are secure.

I previously had the spring loaded "Southco" fasteners.  Piano hinges are way better...

- Pat

Thanks sir. Those pics are very helpful. 

piano hinge gives a nice clean install.  I used skybolt cloc’s on the rear cowl to fuselage attachment.  

RSS

New from Zenith:

Zenith Planes For Sale 
 

Classified listing for buying or selling your Zenith building or flying related stuff...


Custom Instrument Panels
for your Zenith
:

Custom instrument panels are now available directly from Zenith Aircraft Company exclusively for Zenith builders and owners. Pre-cut panel, Dynon and Garmin avionics, and more.


Zenith Homecoming Tee:


Zenair Floats


Flying On Your Own Wings:
A Complete Guide to Understanding Light Airplane Design, by Chris Heintz


Builder & Pilot Supplies:

Aircraft Insurance:

 
 

West Coast USA:

 
Pro Builder Assistance:

 

Transition training:

Lavion Aero

K&S Aviation Services

Aircraft Spruce & Specialty for all your building and pilot supplies!

How to videos from HomebuiltHELP.com

Developed specifically for Zenith builders (by a builder) these videos on DVD are a great help in building your own kit plane by providing practical hands-on construction information. Visit HomebuiltHelp.com for the latest DVD titles.

© 2024   Created by Zenith.Aero.   Powered by

Badges  |  Report an Issue  |  Terms of Service