Online Community of Zenith Builders and Flyers
It's been a long winter but its' finally warming up enough to work on the CH 750 STOL in the shop again.
I've looked through the Construction Guides, Assembly Manuals , Forums and the Help Videos but I couldn't find an answer for the psi to use when you use the pneumatic riveter.
Question: what pressure do you set your air compressor to when you use your pneumatic riveter?
Is it subjective?
Will higher settings, ie 85-90 psi, cause damage to the structure, or just pull the rivet faster?
I think that was the setting I used last year but not sure.
Many Thanks for the assistance.
I think for the A4's I had used around 50 psi and for A5 rivets maybe 60-65 max. I'm sure others will weigh in with their settings as well. After you pull a few you'll get a feel for what setting works best on your air regulator as I'm sure they're all somewhat different. Shoot for a setting that you detect is cleanly and consistently pulling that stem from the rivet and forming the rivet head with the least amount of air pressure needed. Higher pressure settings like 85-90 can make your riveter head bounce on the skin. Have fun building!
I use mine at 135psi. never had a problem and I have done thousands of them.
Years ago I was told 90 PSI in the rudder class I took. I've used that setting to pull A4 & A5 rivets with great success. I push into the rivet when I pull the trigger and haven't had any bounce problems.
I've been using the same pressure and technique as Tim, no problems so far. Good luck with your project!
I use the 85-90 psi setting at the compressor and then fine tune using the 1/4 turn valve at the rivet gun. Any method you use to eliminate the bounce should work fine. These multi-grip length rivets are pretty easy to use.
Best Regards, Larry Zepp Zodiac 650 builder, Fort Wayne, IN
Hey Bob, just to help you be thoroughly confused I've been pulling both my A-4 and A-5 rivets at about 65 psi and that has worked well for me. Have fun with your build.
Thanks Very Much to everyone who took the time to answer my question.
It's almost time to be able to put the propane heater, and insulated overalls away and make some serious advances with the kit.
Best of luck to everyone with your builds.
I recently was riveting powder coated tip fences to the HT. I had pre-drilled the rivet holes prior to the powder coat and had to clean them out with the drill bit to remove the powder coating in the hole so the rivet would fit. When I used my pneumatic riveter with the A4 rivets, I noticed the powder coat had delaminated in a circle around some of the rivets! Apparently, the pneumatic riveter pulls the rivet so fast the air pushed out from under the rivet head and tracked underneath the powder coat, lifting it off the metal!!!
Next time, I'm going to use a hand riveter if I'm in a similar situation with a powder coated piece!