Good day you all,

I have a CH701sp powered by a Subaru EA-81 and it's running great. After extensive testing, I realized that my 2 x 10 gals fuel tanks (1 per wing) are not enough fuel for my taste.

I 'm running around 6.2 gals/hour which gives me 2.5 hours + 1/2 hour reserve. This is pretty tight for my taste. I would like to ADD 2 x 10gals more fuel tanks (1 each wing). My original tanks have the fuel gauges in them and I dont expect to run the additional tanks on separate gauges. My original tanks have 2 fuel pickups each (one in front, 1 in back) hooked together.

My original tanks are on the first inboard wing bay, the 2 added ones will be in the next bay.

Question is, how do I plumb the 2 tanks together (2 each wing) ?

Is there an anti-return valve that I have to install between the 2 tanks so that when I bank hard the fuel wont go towards the wingtip on the low wing. ?

I know Zenair sells additional fuel tanks for the 701, do they provide drawings on how-to do this ?

Anybody running this setup ???

Thanks for any insight in this matter.

Normand

CH701sp

Views: 1450

Reply to This

Replies to This Discussion

6.2 gallons an hour??? Holy Molly! I though the EA 81 would do much better than that.
Hi Vance,
It would do better IF I leaned sometime and I did not run it at 90% throttle all the time..
This engine can take it without problem and hold 100% throttle at all time ... I just like to get somewhere faster....

I would say around 5 gals an hour is more conservative if you run at 75% throttle like you should....
Regards,
Norm

Salut

Zenair's drawings numbers for this are 7-WTO-1 and 7-WTO-2. They do not connect the tanks together, they use one gascolator for the inboard tank and one for the others, with a three way valve instead of the original one between the gascolators and the engine.

If you connect them together I do not think you need a check valve, as long as you do coordinated turns the fuel will not go to the lower wing. In the standard 2X10 gal setup the tanks are connected together and there is no such problem.

If I remember correctly in Canada you need one fuel gage for each tank, you may want to confirm that if you do the modification.

Regards,

François

Hi Francois,

Merci pour les infos. I dont have these pages... Newer plan set I guess... I would rather connect them together in the wing without having to get 2 more fuel lines out to a new valve.

Thanks,

Norm

Normand, I have the old style 5.5 gal. tanks from zenith l as outboard aux. tanks, mine are plumbed with a gas tank switching valve [dual tank pick-up style] between the two tanks, and hooked up thru the normally closed port only , I plugged the normally open port, the main tank has a "T" fitting that allows fuel from the outboard to flow into the main or thru to the engine , you only have to energize the valve when the main is half tank or less , since the outboard tank is higher and closer to the spar it flows down and aft. also you dont need gages since the main will read apx 1/2 tank until the aux. is empty , you also dont need complex fuel valves, just right /left /both and two toggle switches...   BOB

Be careful! Extra fuel extra weight. This will limit passenger. Capacity. Just caution to add to check list I learned the hard way. Fly safe.

Hi Normand,

I only have a 601XL but the process should be the same. I added extra tanks in the wings and connected them up with a pump with an internal check valve. I use the original tanks as "main" tanks and just top them up from the "aux" tank. I only have an extra switch for each pump in the cockpit. Works a treat.

Cheers

Darryl

RSS

New from Zenith:

Zenith Planes For Sale 
 

Classified listing for buying or selling your Zenith building or flying related stuff...


Custom Instrument Panels
for your Zenith
:

Custom instrument panels are now available directly from Zenith Aircraft Company exclusively for Zenith builders and owners. Pre-cut panel, Dynon and Garmin avionics, and more.


Custom Upholstery Kits for your Zenith Aircraft:

Zenith Vinyl Upholstery Kits


Zenith Apparel from EAA:


Zenair Floats


Flying On Your Own Wings:
A Complete Guide to Understanding Light Airplane Design, by Chris Heintz


Builder & Pilot Supplies:

How to videos from HomebuiltHELP.com

Developed specifically for Zenith builders (by a builder) these videos on DVD are a great help in building your own kit plane by providing practical hands-on construction information. Visit HomebuiltHelp.com for the latest DVD titles.

Aircraft Insurance:

 
 

West Coast USA:

 
Pro Builder Assistance:

 

Transition training:

Golden Eagle Aviation

Pianosa Flying Farm

Aircraft Spruce & Specialty for all your building and pilot supplies!

© 2022   Created by Zenith.Aero.   Powered by

Badges  |  Report an Issue  |  Terms of Service